Azure Site Recovery between on-premises VMM sites with SAN replica part 2

This blog post will continue ASR SAN replica configuration from earlier post which can be found from HERE

As we already enabled Snap Mirror from NetApp side we don´t need to create replication group from VMM side. After Adding SMI-S providers to VMM we needed to ran rescan to both providers:
ASRParttwo001

After rescan we checked that Replication groups were ok:
Production:
ASRParttwo002

DR:
ASRParttwo003

Then we needed to create VMM Clouds.
“Primary DR” to production side
ASRParttwo005 ASRParttwo006
“Secondary DR” to DR side
ASRParttwo007 ASRParttwo008

Next we installed ASR provider to both VMM stamps (basic steps, download provider and registration key / Install).

ASRParttwo004

ASRParttwo009

 

Next we needed to Map storage arrays and pools
ASRParttwo010

ASRParttwo011

 

ASRParttwo012

 

and then Configured cloud protection settings (choose primary Cloud)

ASRParttwo013

Choose Configure protection settings
ASRParttwo014

Ensured that replication type is SAN
ASRParttwo015

ASRParttwo016

ASRParttwo017

 

Next we Enabled network mapping
ASRParttwo018

 

ASRParttwo020

and last Enabled replication for replication groups
ASRParttwo021

ASRParttwo022

 

ASRParttwo023

 

That´s it. Basic configuration is now done. Next blog post I will describe the steps how to install/move VMs under ASR Protection and some troubleshooting.

Leave a Reply

Your email address will not be published. Required fields are marked *